administration

I test servers on a temporary basis a lot, and many enterprise servers don't have as user-friendly external port indications, or little OLED displays to provide useful information. They're no-frills because they don't need frills, you just deploy them and they run for years.

I often need to gain access to the server's IPMI/BMC interface to manage the server remotely, and it's not always obvious what IP address is assigned if you don't manually assign one via your router and a MAC address.

I could scan my network for the IP address, but assuming I have the server booted and it's a modern Supermicro or other standard system, I can use ipmitool to grab the BMC IP:

One requirement of the Archdiocese of St. Louis' website is that group administrators are able to publish and unpublish the content inside their groups, and they should also be able to schedule posts for automated publishing and unpublishing at a later time.

To do this, I used the following modules:

• OG User Roles
• Scheduler
• Publish Content
• [EDIT: I'm now using the Override Node Options module rather than Publish Content - it gives more fine-grained control over visibility of node form options.]

After enabling these modules, I spent a while in the Permissions page, and also created a new user role, "administer nodes." Ironically, I didn't assign the 'administer nodes' permission to this role, because doing so causes a huge mess ('administer nodes' gives waaay too much power to anyone except the site admin—it's best to leave that beast unchecked in most cases).